Quested SB10 Active Subwoofer

Quested SB10 Active Subwoofer
Quested SB10 Active Subwoofer The SB10 is a powered 10″ sub-bass designed to complement all of the full-range

The SB10 is a powered 10″ sub-bass designed to complement all of the full-range monitors in the S-Series. The SB10 will extend the system frequency response down to 20 Hz and increase the systems maximum spl. The filter bypass on the left channel optimises the SB10s performance when it is used as a dedicated LFE monitor in a multi-channel system. With the 2-in 2-out bass management a single SB10 can reinforce a stereo pair of full range cabinets. A long throw 10″ cast chassis driver is mounted in a tuned cabinet constructed of ash veneered 26 mm MDF. Tradition is broken in that the matched 215W RMS amplifier and 2-channel SB10 controller are housed in a separate single 1U rack space unit. Due to this Remote Power the electronics do not suffer the adverse effects caused by the LF vibrations that are created by the drive unit. Calibration and operation of the SB10 controller are easily achieved in comfort with the unit sited close to hand. Quested Recording-and-Computers 6OC

More Information and order online::
Quested SB10 Active Subwoofer



Quested S6R Active Studio Monitors (Pair)

Quested S6R Active Studio Monitors (Pair)
This compact self-powered 2-way active monitor is the ideal choice where space is at a premium; the magnetic shielding also facilitates its use in close proximity to CRT monitors.

The sonic performance of the S6R belies its size the low frequency response being more than adequate for many applications however when an extended bass response is required the infinite baffle cabinet design facilitates perfect integration with SB10R sub-woofer which will extend the frequency response down to 25Hz. The S6R is phase coherent with the S7R and S8R enabling it to be used in combination with both in multi- channel systems. Some typical applications include: speech recording component in multi-channel systems postproduction Audio workstations and location recording. Specification – S6R Size (WxHxD): 170(w) x 285(h) x 240(d) mm Weight: 7.5 kgs Drivers: Bass cone – 1 x 130 mm (5″) High Frequency soft dome – 1 x 28 mm (11/8″) Maximum SPL: 104 dB (c) continuous pink noise @ 1 m (116 dB (c) per pair RMS music) Frequency Response: 75 Hz-20 kHz ± 2 dB Input Connector: XLR and 1/4 inch Jack combo socket Impedance: 10k ohm electronically balanced with RF filters Wiring: Pin 1 ground Sleeve Pin 2 hot Tip Pin 3 cold Ring Sensitivity: -12 dBu to +6 dBu for 96 dB SPL @ 1 m set by 10 position rotary switch on rear Filters Subsonic: -3dB @ 45 Hz 24dB/oct Ultrasonic: -3dB @ 75 kHz 4dB/oct Crossover: 1k19 LF EQ: -2/-4 @ 82 Hz HF EQ: +/- 2dB @ 10 kHz Power Amplifier LF output power: > 65W RMS continuous (note 1) HF output power: > 45W RMS continuous (note 1) T.H.D.: < 0.03% at levels up to 1 dB below clip 20 Hz-20 kHz. typ 0.005% @ 1kHz. Hum + Noise: > -100 dB referred to clip Quested Recording-and-Computers 6O9

More Information and order online::
Quested S6R Active Studio Monitors (Pair)

Quested S8R Active Studio Monitors (Pair)

Quested S8R Active Studio Monitors (Pair)
The S8R is a self-powered 2-way active monitor. Two class A-B amplifiers with a linear power supply are capable of delivering a total of 370 Watts RMS making the S8R the most powerful 2-way monitor available. Twin doubled flared ports in a compact reflex enclosure help keep the dimensions to a minimum. The abundant headroom in the amplifiers and resilient drive units makes for a monitor that is ideally suited for every genre of music from Heavy Metal to the electronic music of today. A perfect choice when a full range response is required without the use of a sub-woofer. Price listed is per pair

Two class A-B amplifiers with a linear power supply are capable of delivering a total of 370 Watts RMS making the S8R the most powerful 2-way monitor availableSize (WxHxD) 300(w) x 430(h) x 370(d) mm. Twin doubled flared ports in a compact reflex enclosure help keep the dimensions to a minimum. The abundant headroom in the amplifiers and resilient drive units makes for a monitor that is ideally suited for every genre of music from Heavy Metal to the electronic music of today. A perfect choice when a full range response is required without the use of a sub-woofer. Being phase coherent with the other models in the S-Series the S8R can be used in combination with them in multi-channel systems. Typical applications include full-range monitors in medium sized control rooms near / mid-field monitoring in larger rooms programming rooms and components in multi-channel systems. Features/Specifications: Weight: 19.2 kgs Drivers Bass cone: 1 x 200 mm (8″) High Frequency soft dome: 1 x 28 mm (1″) Maximum SPL: 110 dB (c) continuous pink noise 1 m (122 dB (c) per pair RMS music) Frequency Response: 50 Hz-20 kHz ± 2 dB Input: Connector: XLR and 1/4 inch Jack combo socket Impedance: 10k electronically balanced with RF filters Sensitivity: -12 dBu to +6 dBu for 96 dB SPL 1 m set by 10 position rotary switch on rear. Filters: Subsonic: -3dB 20 Hz 24dB/oct Ultrasonic: -3dB 75kHz 4dB/oct Crossover: 1k40 LF EQ: -2/-4 42 Hz HF EQ: +/- 2dB 10 kHz Power Amplifier: LF output power: > 220W RMS continuous (note 1) HF output power: > 150W RMS continuous (note 1) T.H.D.: < 0.025 at levels up to 1 dB below clip 20 Hz-20 kHz. typ 0.005 1kHz. Hum + Noise: > -100 dB referred to clip Quested Recording-and-Computers 6OA

More Information and order online::
Quested S8R Active Studio Monitors (Pair)